Back to Blog
Usb burning tool error at 2%7/10/2023 I tried changing the rate in the device manager, but still nothing worked, and return it to the original value. It looks genuine, but I'm not 100% certain. I'm not honestly sure if it's a genuine board or not. I have an old arduino uno that a friend gave me ages ago. I'll try to post answers to questions I found on other topics just to make everyone's life a little easier. Once I hit upload, the pin 13 LED, and TX/RX will flash a few times. The USB cable is fine, I tried it with another uno. ![]() My test sketch is the blinker program, no other wires are connected. It just hangs there and eventually says "An error occurred while uploading the sketch". I know this question has been asked countless times, I looked through over 15 topics but still non of them apply to me, and most don't actually reach a solution.
0 Comments
Read More
Leave a Reply. |